The configuration profile mode sheets are numbered starting with 1, in the order their sheets appear in the spreadsheet window. The default method to increment to the next profile is to activate the Right Sip tube. Puffing on the Right tube decrements the mode to the previous profile. The active profile's number is displayed on the status LEDs when the profile changes and after a short delay whenever no inputs are active. The LEDs are numbered one through five, left to right. After mode five, the fifth LED stays on and the pattern starts over from the left until the nineth mode, then both four and five stay on and the pattern repeats. The sum of the LED numbers indicates the mode number up to 15.
increment_mode
normal
right_sip
decrement_mode
normal
right_puff
Since the command to change between modes is controlled within the mode's profile, another input signal can be used instead of the Right Sip/Puff, if desired. A example would be using the button that activates a scope or zoom in an FPS to also change to the Right Analog mode for aiming, regardless of which mode was active before. This example from Far Cry 4 changes the mode from 1 to 3 and brings up the scope when mp_left_puff is activated.
left_2
toggle
mp_left_puff
increment_mode
normal
mp_left_puff
increment_mode
normal
mp_left_puff
Voice mode commands can also switch the Quadstick directly to any desired mode.
