This setting controls the speed of the mouse relative to the game controller joystick. Adjust the joystick sensitivity for use as a game controller first, then adjust this mouse speed second.
The QMP and CronusPro cannot both access the CronusMax Plus PCPROG port at the same time. Turn this setting off if using the CronusPro while the QMP is open. If using the QMP to relay Quadstick data to the CronusPro PCPROG port, this setting must turned on.
Enables the long hard sip on the side tube to allow the user to activate different configuration files. When activated, a "boing" sound will be heard and the leds will flash rapidly indicating the number for the active file. Move the joystick left-right or up-down to light up the leds for the desired file, then press the lip button.
A long hard puff on the side tube allows the user to temporarily remap the lip button to the next input the user activates. While waiting for the user to select an input, a tone will sound from the speaker. To clear the swap, a long hard puff, followed by pushing on the lip button will restore the original mapping.
If there is no serial connection to the Quadstick, this setting can be used for voice commands when the Quadstick is connected to the PC. This setting overrides any serial connection.
If a serial connection is found to the Quadstick, via a cable or Bluetooth SPP, and the Quadstick is not connected to the PC, turning this setting on will allow configuration file management over that serial connection.
